10/7/2023 0 Comments Joystick xplane![]() The throttle has an OFF range (fuel shut off), then ground idle and then flight range. The throttle twist grip works more like a condition lever, if the governor is operating normally. Unlike the piston governor, the turbine governor governs maximum RPM. In case of governor failure, the governor fails in the current position, leaving the correlator intact, so it will require small adjustments by the pilot. Because the governor adds to the correlator, the change in throttle grip caused by the governor will be relatively small, as big power changes are already absorbed by the correlator. When switched on, the governor will kick in once the throttle has been increased enough to go over 80% RPM. The piston governor adds onto the throttle grip, so unlike the correlator the effect of the governor can be seen on the grip as the throttle will be twisted. By holding the throttle in detent (rolling it below 5% or the customized point on your hardware) it is possible to practice auto-rotations with the engine running, as the then the correlator will not kick in during the flare. The correlator input is added to the throttle twist grip input whenever the throttle is out of detent, which by default is 5% throttle, but can be customized to your throttle hardware with a joystick control curve. The correlator is added after the throttle, and does not change the twist of the throttle grip. In Plane Maker, you can set two control points to define the linear connection. The correlator is a linear collective to throttle linkage that automatically opens the throttle as collective input increases. ![]() Above, you roll the throttle all the way on to enter governing range. It has a range below the idle release button where the engine is shut off. Turbine governor – This changes the throttle to work like a condition lever in normal operation.The governor will only engage at 80% or more rotor RPM Robinson-style piston correlator and governor – This adds a correlator to the throttle, and adds the “detent” to the throttle range surpassing the correlator. ![]() X-Plane 11 governor – this corresponds to checking the governor checkbox in Plane Maker 11 and preserves the behavior for legacy aircraft.This is helpful if you want to code your own governor in a plugin. No governor – this corresponds to leaving the governor checkbox unchecked in Plane Maker 11.In Plane Maker 12, you can choose the type of throttle governor you can equip your helicopter with: The joystick control assignments for collective and throttle don’t change, but there’s a new joystick curve available for Robinson-style throttle control. Existing helicopters retain the default behavior of X-Plane 11 until modified in Plane Maker 12 to opt into one of the new governor systems. X-Plane 12 revises the interaction of collective and throttle control in helicopters.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |